在安裝時，嚴禁用鐵錘等擊打，防止軸向力或徑向力過大損壞軸承或齒輪。一定要將安裝螺栓旋緊之后再旋緊緊力螺栓。

At the time of installation, it is strictly prohibited to use a hammer, such as a hammer, so as to prevent the axial or radial force from damaging the bearing or gear. It is necessary to tighten the bolt when the bolt is tightened.

減速機性能特點

1,產品采用模塊化設計,電動機輸入,輸入軸和孔類型三個方面,并配置腳,法蘭安裝,適用于各種有效的減變速傳動,可以直接取代無級調速,擺線。  

2、能源消耗低、噪音低、振動小,減速機達96%。  

3,使用特殊的寬帶寬壓力電動機,當加載在20 hz - 60赫茲頻率范圍內正常使用。  

4、齒輪滲碳淬火熱處理工藝,采用獨特的低噪聲齒齒形設計,確保產品的使用壽命。  

Performance characteristics of reducer

1, the product adopts modular design, motor input, input shaft and hole type three aspects, and equipped with feet, flange installation, suitable for all kinds of effective variable speed transmission, which can directly replace stepless speed regulation and cycloidal.

2, the energy cumption is low, the noise is low, the vibration is small, and the efficiency of the reducer is up to 96%.

3, the use of a special wide band wide pressure motor when loaded in the range of 20 Hz - 60 Hz is normally used.

4, gear carburizing and quenching heat treatment process, using a unique low noise tooth profile design to ensure the service life of the product.

減速機內部齒輪精度等級 設計減速機時，設計者往往從經濟因素考慮，盡可能比較經濟的確定齒輪精度等級，忽略精度等級是齒輪產生噪聲與側隙的標記。

When the reducer is designed in the gear precision grade of the reducer, the designers often cider the economic factors as much as  to determine the gear precision level as much , and ignore the precision grade as the mark of the gear noise and the backlash.