混流泵

軸套用來保護軸不使它與填料直接摩擦，若長期使用中發現軸套磨損過多，必須換軸套。

IV. Axile sleeve is used to protect the axle from friction

with padding.In long term using, change the axile sleeve

when the sleeve wears down too much.

（五）水泵軸的兩個支承是軸承體內的軸承，軸承體內存有適量潤滑脂以潤滑軸承。

V. Two supportings of water pump axile are bearings in

bearing body.There is some lubricating grease in bearing

body for lubricating bearing.

8、水泵在冬季使用時，停車后應將水泵內和管道內的存水放盡以防凍裂。

If use the pump

in winter, pls run off the water from the pump and pipes.

    9、水泵每使用一個灌溉季節后，應更換潤滑黃油后存放。

Replace the

lubricating oil after using the pump for one irrigation season.

10、水泵工作滿500小時，應仔細拆卸檢查零件的磨損情況，如長期停用，應將運轉部分拆下擦干上油妥善保管。

 6、軸承發熱

 The bearing is

 hot

 1、潤滑油脂不足

 2、潤滑油質量不好或不清潔

 3、軸心沒有對準

 4、軸承松動或磨損

 5、皮帶太緊

 1.Lubricating grease is not enough

 2.The quality of lubricating oil is not

 good or dirty

 3.The axes is not aiming

 4.The bearing is loose or attrition

 5.The belt is too tight.

 1、加油

 2、清洗軸承

 3、找正

 4、修正

 5、適當放松

 1.Add lubrication oil

 2.Wash

 the bearing

 3.Aligning

 4.Amending

 5.Loosen it properly

 7、填料發熱

 The padding is

 1、填料壓得太緊或四周緊密度不夠2、填料壓得偏斜與軸磨損嚴重

 1.The padding is

 pressed too tight or the around compactness is not enough

 2.The padding is

 pressed deflected and the axile wears seriously

 1、旋松壓蓋螺栓高速填料緊密度

 2、松開壓蓋重新均勻地上緊

 1.Loosen the gland bolts to adjust

 2.Loosen the gland bolts and tighten it again.