減速機一般用于低轉速大扭矩的傳動設備，把電動機、內燃機或其它高速運轉的動力通過減速機的輸入軸上的齒數少的齒輪嚙合輸出軸上的大齒輪來達到減速的目的，普通的減速機也會有幾對相同原理齒輪達到理想的減速，大小齒輪的齒數之比，就是傳動比。

Reducer is generally used in driving equipment of low speed high torque, large gear gear output shaft power motor, internal combustion engine or other high speed running through the reducer input shaft less number of teeth on the reducer to achieve the pure of general reducer will have several pairs of the same principle to achieve the ideal effect of gear reducer. The size of the number of teeth of the gear ratio, the transmission ratio is.

安裝前確認電機和減速機是否完好無損，并且嚴格檢查電機與減速機相連接的各部位尺寸是否匹配，這里是電機的定位凸臺、輸入軸與減速機凹槽等尺寸及配合公差。

Before installation, confirm whether the motor and reducer are in good condition, and strictly check whether the size of each part of the motor connected to the reducer is match. Here is the size and fit tolerance of the motor's locating lug, input shaft and reducer groove.

在輸出軸上安裝傳動件時，不允許用錘子敲擊，通常利用裝配夾具和軸端的內螺紋，用螺栓將傳動件壓入，否則有可能造成減速機內部零件的損壞。

When driving parts are installed on the output shaft, it is not allowed to knock with hammers. Usually use assembly jig and inner thread of shaft end to press the transmission parts into bolts with bolts, otherwise, it may cause damage to internal parts of reducer.

減速機的作用

1)降速同時提高輸出扭矩，扭矩輸出比例按步進電機輸出乘減速比，但要注意不能超出減速機額定扭矩。

2)速同時降低了負載的慣量，慣量的減少為減速比的平方。大家可以看一下一般電機都有一個慣量數值。

The function of the reducer

1) reduce the speed and increase the output torque at the same time. The ratio of the torque output to the multiplying and decelerating ratio of the stepper motor output, but we must be careful not to exceed the rated torque of the reducer.

2) speed reduces inertia of load at the same time, and inertia reduces to the square of deceleration ratio. As you can see, general motors have an inertia value.