在帶鋼熱連軋機上使用著許多輥道，它們被分成若干段，每一段輥道或者以獨立的或者以與軋輥同步的速度和方向運送軋件。

為使軋件能夠在輥道中心運行，采用鼓形輥，并且交替地使左右兩邊的水平面稍微傾斜，或者使輥子的軸線與軋件運行方向的交角交替地比直角稍微偏斜一些。

Many roller tables are used on hot strip mills. They are divided into several segments, each section of rollers or parts transported independently or at the same speed and direction with the rollers.

In order to make the workpiece can be run in the center of the drum shaped roller, roller, and alternately on both sides of the horizontal plane or slightly tilted, the roller axis and the running direction of the rolling angle alternately than some slightly skewed angle.

輥道的傳動形式有集體傳動，單獨傳動和空轉輥道三種。

①集體傳動輥道——由一臺電動機同時帶動所有的或其中一部分輥子。通常是4~10根輥子。

②單獨傳動輥道——每個輥子或每兩個輥子由一個單獨電動機帶動。

The drive form of the roller table has three types: collective drive, single drive and roller table.

(1) a collective drive roller - a motor that drives all or some of the rollers at the same time. It is usually the 4~10 root roller.

(2) a separate drive roller track - each roller or two rollers are driven by a single motor.

對于大型軋機來說，尤其是熱軋機必須用動力傳動輥道。多的還是集體傳動式，特別是長度不大而軋件斷面很大時，適宜用集體傳動。單獨傳動輥道通常用于長距離的軋件的傳送。

For large rolling mills, in particular, the hot rolling mill must be powered by a power drive roller. The most important is the collective transmission type, especially when the length is small and the section of the workpiece is very large, it is suitable for the use of collective transmission. The single drive roller is usually used for the transmission of long distance parts.